Cases are published on the ASME website under the Y14 Committee Page at as they are issued. Periodically certain actions of the ASME Y14 Committee may be published as Cases. This Standard will be revised when the Society approves the issuance of a new edition. Approved for public release, distribution is unlimited.Įngineering Product Definition and Related Documentation Practices Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database datab ase at. NOTE: The activities listed above were interested interested in this document as of the date of this document. Review Activities: Army - CR, MI, PT, TM Navy - AS, CG, CH, EC, MC, NP, TD Air Force - 13, 99 DLA - DH OSD - SE NSA - NS Other - CM, MP, DC2 Ĭustodians: Army - AR Navy - SA Air Force - 16Īdopting Activity: Army - AR (Project DRPR-2009-003) Copies of this document may be purchased from The American Society of Mechanical Engineers (ASME), 150 Clove Road, 6th Floor, Little Falls, NJ 07424-2139. Army Research, Development and Engineering Center (ARDEC), ATTN: AMSRD-AAR-QES-E, Picatinny Arsenal, NJ 07806-5000. Proposed changes by DoD activities must be submitted to the DoD Adopting Activity: Commander, U.S. ASME Y14.5-2018 (Revision of ASME Y14.5-2009)ĭimensioning and an d Tolera oleranci ncing ng Engineering Product Definition and Related Documentation PracticesĪ N I N T E R N A T I O N A L S T A N D A R DĪSME Y14.5, Dimensioning and Tolerancing, was adopted on 9 February 2009 for use by the Department of Defense (DoD).

Asme y14.5 pdf